CliffsTestPrep Cisco CCNA
Chapter One
CCNA
Practice Test 1
Directions: For each of the following questions, select the choice that best answers the question or completes the
statement.
1. Of the choices below, which one is needed for
connectivity in a Frame Relay network if Inverse
ARP isn't operational?
A. frame-relay arp
B. frame-relay map
C. frame-relay interface dlci
D. frame-relay Imi-type
2. Look at Figure 1-1. As soon as SwitchB was
added to the network, VLAN connectivity
problems began cropping up. Why?
A. Both switches are in server mode in the same
domain.
B. The revision number of SwitchB was higher
than the revision number of SwitchA.
C. SwitchA was not rebooted prior to adding
SwitchB to the network.
D. V-2 was not enabled.
E. VTP pruning was not activated, so the new
paths of the network have not been
recalculated.
3. Look at Figure 1-2. Note both the IP addresses and
h ... read full excerpt from CliffsTestPrep Cisco CCNA ebook
